Commissioning method of insulating glass production line

1. Lightly place the insulating glass production line in the installation position and correctly place the position order of each section of the production line.

2. The fuselage is leveled. Adjust the height of the leveling bolt on the machine base, so that the supporting surface of the conveyor roller and supporting nylon wheel is the same height, the back wheel on the inclined frame is coplanar, and each section is relatively parallel, and then lock the nut.

3. Fasten the parts to be connected between the sections, and connect the drive chain from the feeding section to the cleaning and drying section. Place the fan and water tank correctly, and connect the air duct and water pipe according to the water and air duct system diagram.

4. Thoroughly check whether the connections of all fasteners of the machine are loose due to transportation vibration, and tighten them one by one (especially whether the connections of each terminal are loose).

5. The grounding wire shall be soft copper core yellow-green insulated wire with sectional area not less than 4 mm2, and the grounding resistance shall not be greater than 4 Ω.

6. Connect the air source and check whether the pipeline is smooth and damaged. The air source pressure is required to be 0.6~0.8Mpa.

7. Turn on the power supply and test whether the rotation direction of each motor is correct and whether the drive sprocket of each section is flexible and stable.

8. Clean the whole machine and tidy the working area.